Some Basic Information about Drain Cleaning – Why There are Blocks and How to Solve Them
All buildings need to be provided with clean water and effective draining of waste so that internal activities will run smoothly. With a proper drainage system of waste, the owners and tenants of a building are ensured of a healthy and safe environment.
There are circumstances that would have drains blocking. It is during this time that the services of a plumber with the right skills to carry out the drain cleaning will be needed. An owner or a tenant will be assured of a clean environment when the plumber will successfully drain the wastes from the building.
We would resort to drain cleaning of our building when at one point or another drains are blocked. Blocked drains are caused by many circumstances. An example would be too big foreign objects that are flushed down the toilet and are too big to pass the drain. There could be hairs that are washed down the sink and have accumulated in the drainage pipes resulting to blockage. Usually, we wash down grease and fatty substances down the sink and this would result to blockage of drainage pipes once they get stuck on the sides of these pipes.
Also, when leaves are not properly swept and disposed off in garbage will find their way easily into the drainage pipes causing a blockage, and also the roots of trees, because of their nature to get water or moisture, can crack the pipes thereby causing a blockage.
One method of which a plumber can perform drain cleaning is by using a hyrdrojetter. A hydrojetter is an instrument that can remove any dirt that has blocked the drains through the very high pressure of water that it releases. Lowering the hydrojetter into the drain, the plumber pushes it until it reaches the area where there is a blockage. The pressurized water will then break down the blockage into small particles, will also get rid of the particles on the sides of the pipes, thus allowing the water to drain drown the waste freely without obstacles.
Another solution for drain blockage is with the use of the drain snake, described as a long and flexible cord composed of wires, and are pushed down into the drain and reaching t the blocked area. The wires at the end of the cord will then be turned by the motor of the instrument causing the obstructions to break down into small particles, then these particles are pushed down the drain and there is a free flow of waste down the drain then.
It is important to be able to know where the blockage is located in order for drain cleaning to be performed effectively.